The unsteady velocity field found in the pump of an automotive torque converter was measured using laser velocimetry. Velocities in the inlet, mid-, and exit planes of the pump were investigated at two significantly different operating conditions: turbine/pump rotational speed ratios of 0.065 and 0.800. A data organization method was developed to visualize the three-dimensional, periodic unsteady velocity field in the rotating frame. For this method, the acquired data are assumed to be periodic at synchronous and blade interaction frequencies. Two shaft encoders were employed to obtain the instantaneous angular position of the torque converter pump and turbine at the instant of laser velocimeter data acquisition. By proper “registration” of the data, visualizing the transient interaction effects between the stator and the pump, and between the pump and the turbine, was possible. Results showed strong cyclic velocity fluctuations in the pump inlet plane as a function of the relative stator-pump position. Typical percent periodic fluctuations in the through flow velocity were 70 percent of the average throughflow velocity. The upstream propagation influence of the turbine on the pump exit plane flow field was seen to be smaller. Percent periodic fluctuations of the throughflow velocity were typically 30 percent. The effect of the stator and turbine on the midplane flow field was seen to be negligible. The incidence angle at the pump inlet fluctuated by 27 and 14 deg for the 0.065 and 0.800 speed ratios, respectively. Typical slip factors at the exit were 0.965 and fluctuated by less than 1 percent.
Skip Nav Destination
Article navigation
July 1996
Research Papers
Laser Velocimeter Measurements in the Pump of an Automotive Torque Converter: Part II—Unsteady Measurements
K. Brun,
K. Brun
Department of Mechanical, Aerospace, and Nuclear Engineering, ROMAC Laboratories, University of Virginia, Charlottesville, VA 22903
Search for other works by this author on:
R. D. Flack,
R. D. Flack
Department of Mechanical, Aerospace, and Nuclear Engineering, ROMAC Laboratories, University of Virginia, Charlottesville, VA 22903
Search for other works by this author on:
J. K. Gruver
J. K. Gruver
Department of Mechanical, Aerospace, and Nuclear Engineering, ROMAC Laboratories, University of Virginia, Charlottesville, VA 22903
Search for other works by this author on:
K. Brun
Department of Mechanical, Aerospace, and Nuclear Engineering, ROMAC Laboratories, University of Virginia, Charlottesville, VA 22903
R. D. Flack
Department of Mechanical, Aerospace, and Nuclear Engineering, ROMAC Laboratories, University of Virginia, Charlottesville, VA 22903
J. K. Gruver
Department of Mechanical, Aerospace, and Nuclear Engineering, ROMAC Laboratories, University of Virginia, Charlottesville, VA 22903
J. Turbomach. Jul 1996, 118(3): 570-577 (8 pages)
Published Online: July 1, 1996
Article history
Received:
February 4, 1994
Online:
January 29, 2008
Connected Content
This is a companion to:
Three-Dimensional Analysis of Partially Open Butterfly Valve Flows
Citation
Brun, K., Flack, R. D., and Gruver, J. K. (July 1, 1996). "Laser Velocimeter Measurements in the Pump of an Automotive Torque Converter: Part II—Unsteady Measurements." ASME. J. Turbomach. July 1996; 118(3): 570–577. https://doi.org/10.1115/1.2836704
Download citation file:
Get Email Alerts
Related Articles
Laser Velocimeter Measurements in the Turbine of an Automotive Torque Converter: Part II—Unsteady Measurements
J. Turbomach (July,1997)
Laser Velocimeter Measurements in the Turbine of an Automotive Torque Converter: Part I—Average Measurements
J. Turbomach (July,1997)
Related Proceedings Papers
Related Chapters
System Automation
Pipeline Operation & Maintenance: A Practical Approach, Second Edition
Dynamic Behavior of Pumping Systems
Pipeline Pumping and Compression Systems: A Practical Approach
Other Components and Variations
Axial-Flow Compressors