A novel fluid for use as a working fluid in a heat pipe has been tested at UCLA. The fluid was discovered originally in use with a device consisting of a metal tube charged with the patented inorganic aqueous solution (IAS), which is evaporated when the tube is evacuated before use. According to the patent, this evaporation leaves a thin film that allows the tube to carry high heat flux loads with low temperature drop across the tube in a solid state mode. However, various experiments with these tubes have produced inconsistent results, and there are some questions as to whether the fluid is completely evaporated. The research on which this work is based is focused on testing whether the charging fluid will operate as the working fluid in a heat pipe, in order to determine the nature of the IAS fluid. A heat pipe apparatus was charged with a biporous wick in order to investigate if the fluid plays a role in heat transfer. There are extensive data for this experiment using water as the working fluid, which will be used to compare the two sets of results. Testing has shown a reduction of the superheat required to drive heat fluxes through a wick compared to water by approximately 40%. Some experiments have shown that the operating (temperature) range of the IAS is much larger than a standard heat pipe. It is theorized that the increase in performance of the IAS is due to an increased thermal conductivity of the wick and increased capillarity. If this fluid is proven to be effective, it would lead to more effective and tunable heat transfer devices.
Skip Nav Destination
e-mail: catton@ucla.edu
Article navigation
June 2011
Research Papers
Utilization of Advanced Working Fluids With Biporous Evaporators
Ivan Catton
e-mail: catton@ucla.edu
Ivan Catton
Los Angeles Mechanical and Aerospace Engineering Department, University of California
, 420 Westwood Plaza, Los Angeles, CA 90095
Search for other works by this author on:
Ivan Catton
Los Angeles Mechanical and Aerospace Engineering Department, University of California
, 420 Westwood Plaza, Los Angeles, CA 90095e-mail: catton@ucla.edu
J. Thermal Sci. Eng. Appl. Jun 2011, 3(2): 021006 (5 pages)
Published Online: July 21, 2011
Article history
Received:
January 25, 2011
Accepted:
April 14, 2011
Online:
July 21, 2011
Published:
July 21, 2011
Citation
Reilly, S. W., and Catton, I. (July 21, 2011). "Utilization of Advanced Working Fluids With Biporous Evaporators." ASME. J. Thermal Sci. Eng. Appl. June 2011; 3(2): 021006. https://doi.org/10.1115/1.4004291
Download citation file:
Get Email Alerts
Cited By
Simulation and Experimental Study of Two-Phase Gas–Liquid Behavior in Two-Dimensional Porous Medium Based on Lattice Boltzmann Method
J. Thermal Sci. Eng. Appl (February 2025)
Effect of Variation of the Aspect Ratio of Rectangular Twisted Tapes Inserted in a Circular Pipe on the Thermal Performance
J. Thermal Sci. Eng. Appl (February 2025)
Design Optimization of a Shell-and-Tube Heat Exchanger Based on Variable Baffle Cuts and Sizing
J. Thermal Sci. Eng. Appl (February 2025)
Energy-Efficient Three-Wheel Bleedless Electrical Environmental Control System for a Passenger Aircraft
J. Thermal Sci. Eng. Appl (February 2025)
Related Articles
Effect of Liquid Properties on Phase-Change Heat Transfer in Porous Wick Structures
J. Heat Transfer (March,2016)
Evaporation Heat Transfer in Sintered Porous Media
J. Heat Transfer (August,2003)
Experimental Investigation of a Flat-Plate Oscillating Heat Pipe With Groove-Enhanced Minichannels
J. Thermal Sci. Eng. Appl (December,2020)
Transport in Passive, High Thermal, Conductivity Heat Spreaders
J. Heat Transfer (August,2011)
Related Proceedings Papers
Related Chapters
Energy Balance for a Swimming Pool
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Chitosan-Based Drug Delivery Systems
Chitosan and Its Derivatives as Promising Drug Delivery Carriers
The Special Characteristics of Closed-Cycle Gas Turbines
Closed-Cycle Gas Turbines: Operating Experience and Future Potential