Paint-based protective films (PPFs) are used to protect condenser tubes from corrosion and erosion but have been shown to be susceptible to biofouling. Here, the biocidal properties of copper-oxide fillers incorporated into PPFs are explored in this paper. Specifically, two PPFs filled with 20% and 50% filler (by weight) are tested in parallel with a nonbiocidal ordinary epoxy PPF, and bare stainless steel tube. Using double-pipe co-current flow heat exchangers installed at a thermal power plant, actual cooling water exiting the condenser is evenly distributed between the test tubes. Heat transfer in the condenser is simulated by heated water flowing through each annulus of the double-pipe heat exchangers, thereby maintaining repeatable outer convection conditions. An exposure test of 125 days shows that the 50% biocide-filled PPF has the lowest fouling factor of all the tubes. The nonbiocidal epoxy has the highest fouling factor and the 20% filled PPF behaves similarly. Both of these are greater than the bare stainless steel control tube. The 50% filled PPF is compared to the fouling of an existing admiralty brass tube and the shapes of the fouling curves are similar. This evidence suggests that provided the filler concentration is sufficiently high, there is the potential for the copper-oxide filler to reduce the asymptotic composite fouling factor by virtue of its antibacterial properties.
Skip Nav Destination
Article navigation
August 2018
Research-Article
The Antifouling Effects of Copper-Oxide Filler Incorporated Into Paint-Based Protective Films Applied to Steam Surface Condenser Tubes
H. C. R Reuter,
H. C. R Reuter
Department of Mechanical Engineering,
Stellenbosch University,
Stellenbosch 7599, South Africa
Stellenbosch University,
Stellenbosch 7599, South Africa
Search for other works by this author on:
M. Owen,
M. Owen
Department of Mechanical Engineering,
Stellenbosch University,
Stellenbosch 7599, South Africa
Stellenbosch University,
Stellenbosch 7599, South Africa
Search for other works by this author on:
J. L. Goodenough
J. L. Goodenough
Search for other works by this author on:
H. C. R Reuter
Department of Mechanical Engineering,
Stellenbosch University,
Stellenbosch 7599, South Africa
Stellenbosch University,
Stellenbosch 7599, South Africa
M. Owen
Department of Mechanical Engineering,
Stellenbosch University,
Stellenbosch 7599, South Africa
Stellenbosch University,
Stellenbosch 7599, South Africa
J. L. Goodenough
1Corresponding author.
Contributed by the Heat Transfer Division of ASME for publication in the JOURNAL OF THERMAL SCIENCE AND ENGINEERING APPLICATIONS. Manuscript received May 3, 2017; final manuscript received January 14, 2018; published online May 8, 2018. Assoc. Editor: Amir Jokar.
J. Thermal Sci. Eng. Appl. Aug 2018, 10(4): 041015 (6 pages)
Published Online: May 8, 2018
Article history
Received:
May 3, 2017
Revised:
January 14, 2018
Citation
Reuter, H. C. R., Owen, M., and Goodenough, J. L. (May 8, 2018). "The Antifouling Effects of Copper-Oxide Filler Incorporated Into Paint-Based Protective Films Applied to Steam Surface Condenser Tubes." ASME. J. Thermal Sci. Eng. Appl. August 2018; 10(4): 041015. https://doi.org/10.1115/1.4039354
Download citation file:
Get Email Alerts
Cited By
Thermal Characteristics and Dryer Performance Analysis of Double Pass Solar Collector Powered by Copper and Iron Oxide
J. Thermal Sci. Eng. Appl (February 2025)
Design Optimization of a Shell-and-Tube Heat Exchanger Based on Variable Baffle Cuts and Sizing
J. Thermal Sci. Eng. Appl (February 2025)
Energy-Efficient Three-Wheel Bleedless Electrical Environmental Control System for a Passenger Aircraft
J. Thermal Sci. Eng. Appl (February 2025)
Related Articles
Comparative Study of Using R-410A, R-407C, R-22, and R-134a as Cooling Medium in the Condenser of a Steam Power Plant
J. Eng. Gas Turbines Power (February,2015)
Experimental Study of Effusion Cooling With Pressure-Sensitive Paint
J. Eng. Gas Turbines Power (May,2017)
Simulation and Experimental Analysis of a Solar Driven Absorption Chiller With Partially Wetted Evaporator
J. Sol. Energy Eng (February,2010)
Operating Characteristic Investigations in Pulsating Heat Pipe
J. Heat Transfer (December,2006)
Related Proceedings Papers
Related Chapters
Engineering and Physical Modeling of Power Plant Cooling Systems
Thermal Power Plant Cooling: Context and Engineering
Threshold Functions
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies