Natural convection is measured in an enclosure that represents an integral collector storage system (ICS) with an immersed tube-bundle heat exchanger. Heat transfer coefficients for bundles of 240 tubes contained in a thin enclosure of aspect ratio of 9.3:1 and inclined at 30 deg to the horizontal are obtained for a range of transient operating modes and pitch-to-diameter ratios of 1.5, 2.4, and 3.3. Results for isothermal and stratified enclosures yield a correlation for the overall Nusselt number The characteristic temperature difference in the Rayleigh number is that between the average water temperature within the bundle and the tube wall temperature. Nusselt numbers are three times larger than those for a similarly configured single-tube and an eight-tube bundle. This increase is attributed to stronger fluid motion within the bundle and higher overall large scale circulation rates in the enclosure.
Skip Nav Destination
e-mail: jhd@me.umn.edu
e-mail: kulacki@me.umn.edu
Article navigation
February 2005
Technical Papers
Thermal Characterization of Prototypical Integral Collector Storage Systems With Immersed Heat Exchangers
W. Liu,
W. Liu
Department of Mechanical Engineering, University of Minnesota 11 Church Street, SE, Minneapolis, Minnesota 55455 USA
Search for other works by this author on:
J. H. Davidson, Fellow of ASME,
e-mail: jhd@me.umn.edu
J. H. Davidson, Fellow of ASME
Department of Mechanical Engineering, University of Minnesota 11 Church Street, SE, Minneapolis, Minnesota 55455 USA
Search for other works by this author on:
F. A. Kulacki, Fellow of ASME
e-mail: kulacki@me.umn.edu
F. A. Kulacki, Fellow of ASME
Department of Mechanical Engineering, University of Minnesota 11 Church Street, SE, Minneapolis, Minnesota 55455 USA
Search for other works by this author on:
W. Liu
Department of Mechanical Engineering, University of Minnesota 11 Church Street, SE, Minneapolis, Minnesota 55455 USA
J. H. Davidson, Fellow of ASME
Department of Mechanical Engineering, University of Minnesota 11 Church Street, SE, Minneapolis, Minnesota 55455 USA
e-mail: jhd@me.umn.edu
F. A. Kulacki, Fellow of ASME
Department of Mechanical Engineering, University of Minnesota 11 Church Street, SE, Minneapolis, Minnesota 55455 USA
e-mail: kulacki@me.umn.edu
Contributed by the Solar Energy Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS and presented at the ISEC2004 Portland, Oregon, July 1–14, 2004. Manuscript received by the ASME Solar Division April 28, 2004; final revision May 10, 2004. Associate Editor: A. Steinfeld.
J. Sol. Energy Eng. Feb 2005, 127(1): 21-28 (8 pages)
Published Online: February 7, 2005
Article history
Received:
April 28, 2004
Revised:
May 10, 2004
Online:
February 7, 2005
Citation
Liu , W., Davidson , J. H., and Kulacki, F. A. (February 7, 2005). "Thermal Characterization of Prototypical Integral Collector Storage Systems With Immersed Heat Exchangers ." ASME. J. Sol. Energy Eng. February 2005; 127(1): 21–28. https://doi.org/10.1115/1.1824106
Download citation file:
Get Email Alerts
Analysis of Erosion of Surfaces in Falling Particle Concentrating Solar Power
J. Sol. Energy Eng (April 2025)
Related Articles
Natural Convection from a Horizontal Tube Heat Exchanger Immersed in a Tilted Enclosure
J. Sol. Energy Eng (February,2003)
Natural Convective Flow and Heat Transfer in a Collector Storage with an Immersed Heat Exchanger: Numerical Study
J. Sol. Energy Eng (August,2005)
Natural Convection From a Tube Bundle in a Thin Inclined Enclosure
J. Sol. Energy Eng (May,2004)
Transient Natural Convection Heat Transfer Correlations for Tube Bundles Immersed in a Thermal Storage
J. Sol. Energy Eng (May,2007)
Related Chapters
Numerical Analysis of a Latent Heat Storage Heat Exchanger Considering the Effect of Natural Convection
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)
An Analysis of the Feasibility of Photoelectric Technique Applied in Defrost-Control
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)
Hydrodynamic Mass, Natural Frequencies and Mode Shapes
Flow-Induced Vibration Handbook for Nuclear and Process Equipment