This paper presents the results of low-cycle fatigue testing and analysis of 26 piping components and butt-welded sections. The test specimens were fabricated from Type-304 stainless steel and carbon steel, materials which are typically used in the primary piping of light water nuclear reactors. Components included 6-in. elbows, tees, and girth butt-welded straight sections. Fatigue testing consisted of subjecting the specimens to deflection-controlled cyclic bending with the objective of simulating system thermal expansion type loading. Tests were conducted at room temperature and 550 deg F, with specimens at room temperature subjected to 1050 psi constant internal hydraulic pressure in addition to cyclic bending. In two tests at room temperature, however, stainless steel elbows were subjected to combined simultaneous cyclic internal pressure and cyclic bending. Predictions of the fatigue life of each of the specimens tested have been made according to the procedures specified in NB-3650 of Section III[1] in order to assess the code design margin. For the purpose of the assessment, predicted fatigue life is compared to actual fatigue life which is defined as the number of fatigue cycles producing complete through-wall crack growth (leakage). Results of this assessment show that the present code fatigue rules are adequately conservative.
Skip Nav Destination
Article navigation
August 1974
Research Papers
Low Cycle Fatigue of Nuclear Pipe Components
J. D. Heald,
J. D. Heald
Applied Mechanics Development, Boiling Water Reactor Systems Department, General Electric Co., San Jose, Calif.
Search for other works by this author on:
E. Kiss
E. Kiss
Applied Mechanics Development, Boiling Water Reactor Systems Department, General Electric Co., San Jose, Calif.
Search for other works by this author on:
J. D. Heald
Applied Mechanics Development, Boiling Water Reactor Systems Department, General Electric Co., San Jose, Calif.
E. Kiss
Applied Mechanics Development, Boiling Water Reactor Systems Department, General Electric Co., San Jose, Calif.
J. Pressure Vessel Technol. Aug 1974, 96(3): 171-176 (6 pages)
Published Online: August 1, 1974
Article history
Received:
February 14, 1974
Online:
October 25, 2010
Article
Article discussed|
View article
Connected Content
Citation
Heald, J. D., and Kiss, E. (August 1, 1974). "Low Cycle Fatigue of Nuclear Pipe Components." ASME. J. Pressure Vessel Technol. August 1974; 96(3): 171–176. https://doi.org/10.1115/1.3454163
Download citation file:
Get Email Alerts
Cited By
Influence of water cover on the blast resistance of circular plates
J. Pressure Vessel Technol
Dynamic response and damage analysis of a large steel tank impacted by an explosive fragment
J. Pressure Vessel Technol
Surface Strain Measurement for Non-Intrusive Internal Pressure Evaluation of A Cannon
J. Pressure Vessel Technol
Related Articles
Effects of Water Flow Rate on Fatigue Life of Carbon Steel in Simulated LWR Environment Under Low Strain Rate Conditions
J. Pressure Vessel Technol (February,2003)
Effect of Loading on Stress Intensification Factors
J. Pressure Vessel Technol (February,2006)
Experimental Stress Analysis for Four 24-in. ANSI Standard B16.9 Tees
J. Pressure Vessel Technol (November,1977)
Equibiaxial Low-Cycle Fatigue Properties of Typical Pressure-Vessel Steels
J. Basic Eng (December,1966)
Related Proceedings Papers
Related Chapters
Pressure Testing
Process Piping: The Complete Guide to ASME B31.3, Third Edition
Openings
Guidebook for the Design of ASME Section VIII Pressure Vessels, Third Edition
Openings
Guidebook for the Design of ASME Section VIII Pressure Vessels