Line heating (LH) is a method of forming curved thick plates. Residual deformation of a steel plate is obtained by applying heat to the plate. Heat transfer analysis between a torch and the steel plate is essential to control the residual deformation of the steel plate in LH. This paper presents an analysis of the heat transfer during LH. The mechanism of combustion flame from a torch is simplified as an impinging gas jet. A turbulent thermal fluid flow analysis is employed to determine the temperature field. Results of numerical and experimental approaches are compared to verify the proposed analysis procedure. The parametric analysis shows that the nozzle diameter and the tip clearance are the important factors of the heat flux induced by the flame.
Skip Nav Destination
Article navigation
November 2003
Technical Papers
Analysis of Heat Transfer Between the Gas Torch and the Plate For the Application of Line Heating
Jong Gye Shin, Mem. ASME, Associate Professor,,
Jong Gye Shin, Mem. ASME, Associate Professor,
Dept. of Naval Architecture and Ocean Engineering, Research Institute of Marine Systems Engineering, Seoul National University, Seoul, 151-744 Korea
Search for other works by this author on:
Jong Hun Woo, Graduate Student,
Jong Hun Woo, Graduate Student,
Dept. of Naval Architecture and Ocean Engineering, Seoul National University, Seoul, 151-744 Korea
Search for other works by this author on:
Jong Gye Shin, Mem. ASME, Associate Professor,
Dept. of Naval Architecture and Ocean Engineering, Research Institute of Marine Systems Engineering, Seoul National University, Seoul, 151-744 Korea
Jong Hun Woo, Graduate Student,
Dept. of Naval Architecture and Ocean Engineering, Seoul National University, Seoul, 151-744 Korea
Contributed by the Manufacturing Engineering Division for publication in the JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING. Manuscript received April 2002; Revised April 2003. Associate Editor: R. Smelser.
J. Manuf. Sci. Eng. Nov 2003, 125(4): 794-800 (7 pages)
Published Online: November 11, 2003
Article history
Received:
April 1, 2002
Revised:
April 1, 2003
Online:
November 11, 2003
Citation
Shin, J. G., and Woo, J. H. (November 11, 2003). "Analysis of Heat Transfer Between the Gas Torch and the Plate For the Application of Line Heating ." ASME. J. Manuf. Sci. Eng. November 2003; 125(4): 794–800. https://doi.org/10.1115/1.1616949
Download citation file:
Get Email Alerts
A Study on the Influence of Polypropylene Melt Flow Index on Nonwoven Fibers Produced Through Hot Melt Centrifugal Spinning
J. Manuf. Sci. Eng (April 2025)
Arc Characteristics of Aluminum Alloy Double-Wire High-Frequency Pulsed GMAW
J. Manuf. Sci. Eng (April 2025)
Related Articles
A Model for Simulating the Performance of a Pavement Heating System as a Supplemental Heat Rejecter With Closed-Loop Ground-Source Heat Pump Systems
J. Sol. Energy Eng (November,2000)
Optically
Based Rapid Heat Transfer Measurements in Complex Internal
Flows
J. Heat Transfer (December,2007)
Laser Repetitive Pulse Heating of Steel Surface: A Material Response to Thermal Loading
J. Manuf. Sci. Eng (August,2002)
Related Proceedings Papers
Related Chapters
Thermoelectric Coolers
Thermal Management of Microelectronic Equipment
Conclusion
Introduction to Finite Element, Boundary Element, and Meshless Methods: With Applications to Heat Transfer and Fluid Flow
Adding Surface While Minimizing Downtime
Heat Exchanger Engineering Techniques