... coupled by means of an interstitial Nusselt number. The enthalpy method is applied to account for phase change. The governing equations are solved using a finite-volume approach. Effects of volume shrinkage/expansion are considered for different interstitial heat transfer rates between the foam and PCM...

... fluid velocities are calculated by means of an enthalpy balance. The experimental data are compared with Vijayan’s model, developed for large scale loops in steady-state conditions, corrected with a parameter that takes into account the loop inclination. The dynamical behavior is always stable. The time...

... enthalpy model. The effects of the electron thermal conductivity models, ballistic range, and laser fluence on the melting and resolidification were also investigated. The modified thermal conductivities defined by Eqs. 27 , 28 are used to obtain the coefficients for Grid Points W and E...

...R. J. Goldstein; K. S. Kulkarni Energy separation is a spontaneous redistribution of total energy (enthalpy) in a fluid without external work or heat flow, resulting in some portion of fluid having higher total energy (enthalpy) and another portion having lower energy (enthalpy) than...

... volume-averaged energy equations for the foam and the PCM are written and are closed using a heat transfer coefficient. The enthalpy method is employed to account for phase change. The governing equations for the PCM without foam are derived from the porous medium equations. The governing equations...

... to handle solid phase, liquid phase, and mushy zone during melting and solidification processes. The volume-of-fluid method was employed to handle free surfaces. The enthalpy method was used for latent heat. Laser absorptions (Inverse Bremsstrahlung and Fresnel absorption) and thermal radiation...

... “improvement” and correction for liquid enthalpy approximation is given by adding the “pressure correction,” v d P , to the corresponding saturation value. It is shown that such correction given for isothermal processes is generally valid for isentropic processes only. Analysis of water real properties, over...

... fraction, if values of “thermodynamic” quality are available. However, the standard heat balance is usually stated as a function of the “flow” quality. Therefore, we should search for a new heat balance between the mixture enthalpy, based on “thermodynamic” quality, and the absorbed heat. This paper...

... indicate a strong near-field enhancement confined to a very small area (nanometer scale). A multidimensional, numerical model was built to simulate the heat transfer through the silicon. An explicit scheme of the enthalpy method was employed to track the solid∕liquid phase boundary. The experiment...

... in the JOURNAL OF HEAT TRANSFER . Manuscript received by the Heat Transfer Division August 8, 2003; revision received June 18, 2004. Associate Editor: S. P. Vanka. 08 August 2003 18 June 2004 26 01 2005 numerical analysis heat conduction melting freezing two-phase flow enthalpy...

... are written for the solid metal foam and the PCM and are closed using an interstitial heat transfer coefficient. The enthalpy method is employed to account for phase change. The governing equations are solved implicitly using the finite volume method on a fixed grid. The influence of Rayleigh, Stefan...

... of a continuous casting mold. Enthalpy method was employed to model the solidification of continuously moving metal. The effect of basic process parameters mainly superheat, withdrawal velocity, mold cooling rate and the post mold cooling rate on the heat transfer was studied. The results of cases run with air...

... the distinct diffusion coefficients of different species. Results have been obtained for a number of two-dimensional nonreacting and reacting free shear flows under normal and zero gravity. For nonreacting flows, total enthalpy and elemental mass fractions have been used as the transported conserved scalars...

...X. Pu, Graduate Student, A fully implicit control-volume finite element method is used to analyze the phase change during DC casting of aluminum alloy. The mathematical model is based on the integral form of the enthalpy equation. A Eulerian-Lagrangian transformation, together with a deforming grid...