This paper reported three-dimensional numerical simulations of the steady laminar flow and heat transfer in corrugated-undulated channels with sinusoidal waves, aiming to investigate the effects of intersection angles between corrugated and undulated plate and Reynolds number (Re) on the flow and heat transfer. The simulations are conducted by using multi-channel computational domain for three different geometries. The code is validated against experimental results and then data for Nusselt number (Nu) and friction factor are presented in a Re range of , and intersection angle range of . The simulation confirms the changes of (averaged over undulated plate) and (averaged over corrugated plate) with representing different characteristics. As increases, Nu ( or ) is about 2–16 times higher for the corrugated-undulated configurations CP-UH1 and CP-UP1 and the concomitant is about 4–100 higher, when compared to a straight channel having square cross section. The minimum of local Nu ( or ) is situated at the four contact points where the top plate touches the bottom one, and the high Nu is located upstream of the crest of the conjugate duct. Performance evaluation for the CP-UH1 channel shows that the goodness factors are larger than 1 with the straight channel having a square cross section as a reference, and the geometry channel has optimal flow area goodness.
Skip Nav Destination
e-mail: yjxiangwise@hotmail.com
Article navigation
Research Papers: Special Issue On Boiling And Interfacial Phenomena
Effects of Intersection Angles on Flow and Heat Transfer in Corrugated-Undulated Channels With Sinusoidal Waves
Jixiang Yin,
Jixiang Yin
School of Energy and Power Engineering,
e-mail: yjxiangwise@hotmail.com
Xi’an Jiaotong University
, Xi’an 710049, P. R. C.
Search for other works by this author on:
Guojun Li,
Guojun Li
School of Energy and Power Engineering,
Xi’an Jiaotong University
, Xi’an 710049, P. R. C.
Search for other works by this author on:
Zhenping Feng
Zhenping Feng
School of Energy and Power Engineering,
Xi’an Jiaotong University
, Xi’an 710049, P. R. C.
Search for other works by this author on:
Jixiang Yin
School of Energy and Power Engineering,
Xi’an Jiaotong University
, Xi’an 710049, P. R. C.e-mail: yjxiangwise@hotmail.com
Guojun Li
School of Energy and Power Engineering,
Xi’an Jiaotong University
, Xi’an 710049, P. R. C.
Zhenping Feng
School of Energy and Power Engineering,
Xi’an Jiaotong University
, Xi’an 710049, P. R. C.J. Heat Transfer. Aug 2006, 128(8): 819-828 (10 pages)
Published Online: January 7, 2006
Article history
Received:
May 23, 2005
Revised:
January 7, 2006
Citation
Yin, J., Li, G., and Feng, Z. (January 7, 2006). "Effects of Intersection Angles on Flow and Heat Transfer in Corrugated-Undulated Channels With Sinusoidal Waves." ASME. J. Heat Transfer. August 2006; 128(8): 819–828. https://doi.org/10.1115/1.2222378
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
Frictional Performance of U-Type Wavy Tubes
J. Fluids Eng (September,2003)
Optimization of Fin Performance in a Laminar Channel Flow Through Dimpled Surfaces
J. Heat Transfer (February,2009)
Related Proceedings Papers
Related Chapters
The Design and Implement of Remote Inclinometer for Power Towers Based on MXA2500G/GSM
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3
Heat Generated in Pipe Flows Due to Friction
Everyday Heat Transfer Problems: Sensitivities to Governing Variables
Hydraulic Resistance
Heat Transfer & Hydraulic Resistance at Supercritical Pressures in Power Engineering Applications