The objective of this paper is to provide optimization of falling film LiBr solution on a horizontal single tube based on minimization of entropy generation. Flow regime is considered to be laminar. The effect of boiling has been ignored and wall temperature is constant. Velocity, temperature and concentration distributions are numerically determined and dimensionless correlations are obtained to predict the average heat transfer coefficient and average evaporation factor on the horizontal tube. Thermodynamic imperfection due to passing lithium bromide solution is attributed to nonisothermal heat transfer; fluid flow friction and mass transfer irreversibility. Scale analysis shows that the momentum and mass transfer irreversibilities can be ignored at the expense of heat transfer irreversibility. In the process of optimization, for a specified evaporation heat flux, the entropy generation accompanying the developed dimensionless heat and mass transfer correlations has been minimized and the optimal geometry and the optimum thermal hydraulic parameters are revealed. The investigation cited here indicates the promise of entropy generation minimization as an efficient design and optimization tool.

Issue Section:
Heat and Mass Transfer
Keywords:
liquid films, optimisation, film flow, pipe flow, laminar flow, two-phase flow, heat transfer, evaporation, friction, mass transfer, irreversible thermodynamics, minimum entropy methods, solutions, Absorption, Desorption, Film, Heat Transfer, Optimization, Second Law
Topics:
Absorption, Entropy, Evaporation, Heat, Heat transfer, Mass transfer, Optimization, Friction, Temperature, Fluid dynamics, Generators, Modeling
1.
Kocamustafaogullari
,
G.
, and
Chen
,
I. Y.
,
1988
, “
Falling Film Heat Transfer Analysis on a Bank of Horizontal Tube Evaporator
,”
AIChE J.
,
34
(
9
), pp.
1539
–
1549
.
2.
Wang, C. Q., Lu, Z., Li, D. Q., Yu-CHI, B., and Sun, Y. G., 1995, “Heat and Mass Transfer in Falling Film Generator of LiBr Absorption Refrigeration Machine,” Proceeding of 19th International Congress of Refrigeration, Vol. IIIa, pp. 209–214.
3.
Kim
,
D. K.
, and
Kim
,
M. H.
,
1999
, “
Heat Transfer Enhancement Characteristics for Falling Film Evaporation on Horizontal Enhanced Tubes With Aqueous LiBr Solution
,”
J. Enhanced Heat Transfer
,
16
(
1
), pp.
66
–
69
.
4.
Jani
,
S.
,
Saidi
,
M. H.
,
Mozafari
,
A.
, and
Heydari
,
A.
,
2004
, “
Modeling of Heat and Mass Transfer in Falling Film Absorption Generators
,”
Scientia Iranica
,
11
(
1&2
),
81
–
91
.
5.
Bejan, A., 1995, Entropy Generation Minimization, CRC Press, p. 47.
6.
Hirschfelder, J. O., Curtiss, F. C., and Bird, R. B., 1954, Molecular Theory of Gases and Liquids, Wiley, New York, p. 700.
7.
Heydari, A., Babadi, F., Jani, S., and Bafkar, R., 2000, “Second Law Based Thermodynamics Analysis of a Lithium Bromide Absorption Chiller,” Proceeding of 4th International and 8th Annual Conference of Iranian Society of Mechanical Engineers, 3, pp. 403–408.
8.
Heydari, A., and Jani, S., 2001, “Entropy-Minimized Optimization of an Automotive Air Conditioning and HVAC System,” SAE Technical Paper Series, 2001-01-0592.
9.
San
,
J. Y.
,
Worek
,
W. M.
, and
Lavan
,
Z.
,
1987
, “
Entropy Generation in Combined Heat and Mass Transfer
,”
Int. J. Heat Mass Transfer
,
30
(
7
), pp.
1359
–
1369
.
10.
Chandra
,
P. G.
, and
Sharma
,
C. P.
, “
Entropy Values of Lithium Bromide-Water Solution and Their Vapors
,”
ASHRAE Trans.
,
2404
, pp.
35
–
46
.
11.
Vanderplaats, G. N., 1987, Numerical Optimization Techniques for Engineering Design, McGraw-Hill, p. 140.
12.
Marsden, J. E., and Tromba A. J., 1996, Vector Calculus, Freeman Company.
Copyright © 2004
 by ASME
You do not currently have access to this content.