The transport processes occurring in an evaporating two-dimensional vapor stem formed during saturated nucleate boiling on a heated surface are modeled and analyzed numerically. From the heater surface heat is conducted into the liquid macro/microthermal layer surrounding the vapor stems and is utilized in evaporation at the stationary liquid–vapor interface. A balance between forces due to curvature of the interface, disjoining pressure, hydrostatic head, and liquid drag determines the shape of the interface. The kinetic theory and the extended Clausius–Clapeyron equation are used to calculate the evaporative heat flux across the liquid–vapor interface. The vapor stem shape calculated by solving a fourth-order nonlinear ordinary differential equation resembles a cup with a flat bottom. For a given wall superheat, several metastable states of the vapor stem between a minimum and maximum diameter are found to be possible. The effect of wall superheat on the shape of the vapor stem is parametrically analyzed and compared with limited data reported in the literature.
Skip Nav Destination
Article navigation
Research Papers
Shape of a Vapor Stem During Nucleate Boiling of Saturated Liquids
J. H. Lay,
J. H. Lay
Mechanical, Aerospace and Nuclear Engineering Department, School of Engineering and Applied Science, University of California, Los Angeles, Los Angeles, CA 90024
Search for other works by this author on:
V. K. Dhir
V. K. Dhir
Mechanical, Aerospace and Nuclear Engineering Department, School of Engineering and Applied Science, University of California, Los Angeles, Los Angeles, CA 90024
Search for other works by this author on:
J. H. Lay
Mechanical, Aerospace and Nuclear Engineering Department, School of Engineering and Applied Science, University of California, Los Angeles, Los Angeles, CA 90024
V. K. Dhir
Mechanical, Aerospace and Nuclear Engineering Department, School of Engineering and Applied Science, University of California, Los Angeles, Los Angeles, CA 90024
J. Heat Transfer. May 1995, 117(2): 394-401 (8 pages)
Published Online: May 1, 1995
Article history
Received:
May 1, 1994
Revised:
August 1, 1994
Online:
December 5, 2007
Citation
Lay, J. H., and Dhir, V. K. (May 1, 1995). "Shape of a Vapor Stem During Nucleate Boiling of Saturated Liquids." ASME. J. Heat Transfer. May 1995; 117(2): 394–401. https://doi.org/10.1115/1.2822535
Download citation file:
Get Email Alerts
Cited By
Related Articles
Framework for a Unified Model for Nucleate and Transition Pool Boiling
J. Heat Transfer (August,1989)
Enhanced Heat Transfer in Biporous Wicks in the Thin Liquid Film Evaporation and Boiling Regimes
J. Heat Transfer (October,2012)
Effect of Liquid Properties on Phase-Change Heat Transfer in Porous Wick Structures
J. Heat Transfer (March,2016)
Theoretical Model for Nucleate Boiling Heat and Mass Transfer of
Binary Mixtures
J. Heat Transfer (December,2003)
Related Proceedings Papers
Related Chapters
Scope of Section I, Organization, and Service Limits
Power Boilers: A Guide to the Section I of the ASME Boiler and Pressure Vessel Code, Second Edition
Pool Boiling
Thermal Management of Microelectronic Equipment, Second Edition