Abstract

Converting existing diesel engines to natural-gas (NG) spark-ignition (SI) operation can reduce the dependence on oil imports and increase energy security. NG-dedicated conversion can be achieved by the addition of a gas injector in the intake manifold and of a spark plug in place of the diesel injector. Previous studies indicated that lean-burn NG inside the traditional diesel chamber (i.e., a bowl-in-piston geometry) is a two-stage combustion (i.e., a fast burn inside the bowl followed by a slower burn inside the squish). However, a triple-peak apparent heat release rate (AHRR) was seen at specific operating conditions (e.g., advanced spark timing (ST) at medium load and engine speed), suggesting that one of the two combustion stages may separate again. Specifically, the burn inside the squish region divided in two events before and after top dead center (TDC). This was due to the different flow motion inside the squish during the compression stroke compared to the one in the expansion stroke, which affected the combustion environments. The result was the apparition of two close peaks in pressure trace, which suggest larger gradients in pressure and temperature than at a more delayed ST. In addition, the phasing and magnitude of three peaks of the heat release changed cycle-to-cycle. As an advanced ST is the usual strategy used in lean-burn SI combustion, understanding phenomena such as the one presented here can be important for reducing engine-out emissions and increase engine efficiency.

References

1.
Weaver
,
C. S.
,
1989
, “
Natural Gas Vehicles-A Review of the State of the Art
,”
SAE
Paper No. 892133.10.4271/892133
2.
Gupta
,
M.
,
Bell
,
S.
, and
Tillman
,
S.
,
1996
, “
An Investigation of Lean Combustion in a Natural Gas-Fueled Spark-Ignited Engine
,”
ASME J. Energy Resour. Technol.
,
118
(
2
), pp.
145
151
.10.1115/1.2792706
3.
Li
,
H.
, and
Karim
,
G. A.
,
2006
, “
Experimental Investigation of the Knock and Combustion Characteristics of CH4, H2, CO, and Some of Their Mixtures
,”
Proc. Inst. Mech. Eng., Part A
,
220
(
5
), pp.
459
471
.10.1243/09576509JPE209
4.
Heywood
,
J. B.
,
1988
,
Internal Combustion Engine Fundamentals
,
McGraw-Hill
,
New York
.
5.
Eghbali
,
B.
,
1984
, “
Natural Gas as a Vehicular Fuel
,”
SAE
Paper No. 841159.10.4271/841159
6.
Xu
,
H.
, and
LaPointe
,
L. A.
,
2015
, “
Combustion Characteristics of Lean Burn and Stoichiometric With Exhaust Gas Recirculation Spark-Ignited Natural Gas Engines
,”
ASME J. Eng. Gas Turbines Power
,
137
(
11
), p.
111511
.10.1115/1.4030500
7.
Germane
,
G. J.
,
Wood
,
C. G.
, and
Hess
,
C. C.
,
1983
, “
Lean Combustion in Spark-Ignited Internal Combustion Engines—A Review
,”
SAE
Paper No. 831694.10.4271/831694
8.
Liu
,
J.
,
2018
, “
Investigation of Combustion Characteristics of a Heavy-Duty Diesel Engine Retrofitted to Natural Gas Spark Ignition Operation
,” Ph.D. dissertation, West Virginia University, Morgantown, WV.
9.
Langness
,
C.
,
Mattson
,
J.
, and
Depcik
,
C.
,
2017
, “
Moderate Substitution of Varying Compressed Natural Gas Constituents for Assisted Diesel Combustion
,”
Combust. Sci. Technol.
,
189
(
8
), pp.
1354
1372
.10.1080/00102202.2017.1295040
10.
Stocchi
,
I.
,
Liu
,
J.
,
Dumitrescu
,
C. E.
,
Battistoni
,
M.
, and
Grimaldi
,
C. N.
,
2019
, “
Effect of Piston Crevices on the Numerical Simulation of a Heavy-Duty Diesel Engine Retrofitted to Natural-Gas Spark-Ignition Operation
,”
ASME J. Energy Resour. Technol.
,
141
(
11
), p.
112204
.10.1115/1.4043709
11.
McMillian
,
M.
,
Richardson
,
S.
,
Woodruff
,
S. D.
, and
McIntyre
,
D.
,
2004
, “
Laser-Spark Ignition Testing in a Natural Gas-Fueled Single-Cylinder Engine
,”
SAE
Paper No. 2004-01-0980.10.4271/2004-01-0980
12.
Reyes
,
M.
,
Tinaut
,
F. V.
,
Gimenez
,
B.
, and
Perez
,
A.
,
2015
, “
Characterization of Cycle-to-Cycle Variations in a Natural Gas Spark Ignition Engine
,”
Fuel
,
140
, pp.
752
761
.10.1016/j.fuel.2014.09.121
13.
Johansson
,
B.
, and
Olsson
,
K.
,
1995
, “
Combustion Chambers for Natural Gas SI Engines—Part 1: Fluid Flow and Combustion
,”
SAE
Paper No. 950469.10.4271/950469
14.
Olsson
,
K.
, and
Johansson
,
B.
,
1995
, “
Combustion Chambers for Natural Gas SI Engines—Part 2: Combustion and Emissions
,”
SAE
Paper No. 950517.10.4271/950517
15.
Dumitrescu
,
C. E.
,
Padmanaban
,
V.
, and
Liu
,
J.
,
2018
, “
An Experimental Investigation of Early Flame Development in an Optical SI Engine Fueled With Natural Gas
,”
ASME J. Eng. Gas Turbines Power
,
140
(
8
), p.
082802
.10.1115/1.4039616
16.
Zuo
,
C.
, and
Zhao
,
J.
,
2001
, “
Development of Diesel Engines Fueled With Natural Gas
,”
SAE
Paper No. 2001-01-3505.10.4271/2001-01-3505
17.
Elgin
,
R.
,
Turner
,
C.
, and
Hagen
,
C.
,
2013
, “
Combustion Chamber Design Considerations for a Compression Ignition Engine to Spark Ignited Natural Gas Engine Conversion
,”
Fall Technical Meeting of the Western States Section of the Combustion Institute
, Fort Collins, CO, Oct. 7–8, Paper No. 13F-41.
18.
Raine
,
R. R.
,
Stephenson
,
J.
, and
Elder
,
S. T.
,
1988
, “
Characteristics of Diesel Engines Converted to Spark Ignition Operation Fueled With Natural Gas
,”
SAE
Paper No. 880149.10.4271/880149
19.
Meyer
,
R.
,
Meyers
,
D.
,
Shahed
,
S. M.
, and
Duggal
,
V. K.
,
1992
, “
Development of a Heavy Duty on-Highway Natural Gas-Fueled Engine
,”
SAE
Paper No. 922362.10.4271/922362
20.
Bommisetty
,
H.
,
Liu
,
J.
,
Kooragayala
,
R.
, and
Dumitrescu
,
C.
,
2018
, “
Fuel Composition Effects in a CI Engine Converted to SI Natural Gas Operation
,”
SAE
Paper No. 2018-01-1137.10.4271/2018-01-1137
21.
Liu
,
J.
, and
Dumitrescu
,
C. E.
,
2019
, “
Numerical Investigation of Methane-Number and Wobbe-Index Effects in Lean-Burn Natural-Gas Spark-Ignition Combustion
,”
Energy Fuels
,
33
(
5
), pp.
4564
4574
.10.1021/acs.energyfuels.8b04463
22.
Donateo
,
T.
,
Tornese
,
F.
, and
Laforgia
,
D.
,
2013
, “
Computer-Aided Conversion of an Engine From Diesel to Methane
,”
Appl. Energy
,
108
, pp.
8
23
.10.1016/j.apenergy.2013.03.002
23.
Liu
,
J.
, and
Dumitrescu
,
C. E.
,
2019
, “
Numerical Simulation of Re-Entrant Bowl Effects on Natural-Gas Spark-Ignition Operation
,”
ASME J. Eng. Gas Turbines Power
,
141
(
6
), p.
061023
.10.1115/1.4043030
24.
Zhang
,
Q.
,
Xu
,
Z.
,
Li
,
M.
, and
Shao
,
S.
,
2016
, “
Combustion and Emissions of a Euro VI Heavy-Duty Natural Gas Engine Using EGR and TWC
,”
J. Natural Gas Sci. Eng.
,
28
, pp.
660
671
.10.1016/j.jngse.2015.12.015
25.
Van Der Weide
,
J.
,
Seppen
,
J. J.
,
Van Ling
,
J. A. N.
, and
Dekker
,
H. J.
,
1988
, “
Experiences With CNG and LPG Operated Heavy Duty Vehicles With Emphasis on U.S. HD Diesel Emission Standards
,”
SAE
Paper No. 881657.10.4271/881657
26.
Liu
,
J.
, and
Dumitrescu
,
C. E.
,
2019
, “
Combustion Partitioning Inside a Natural Gas Spark Ignition Engine With a Bowl-in-Piston Geometry
,”
Energy Convers. Manage.
,
183
, pp.
73
83
.10.1016/j.enconman.2018.12.118
27.
Liu
,
J.
, and
Dumitrescu
,
C. E.
,
2018
, “
Flame Development Analysis in a Diesel Optical Engine Converted to Spark Ignition Natural Gas Operation
,”
Appl. Energy
,
230
, pp.
1205
1217
.10.1016/j.apenergy.2018.09.059
28.
Patterson
,
G. J.
, and
Davis
,
R. S.
,
2009
, “
Geometric and Topological Considerations to Maximize Remotely Mounted Cylinder Pressure Transducer Data Quality
,”
SAE Int. J. Engines
,
2
(
1
), pp.
414
420
.10.4271/2009-01-0644
29.
Randolph
,
A. L.
,
1990
, “
Cylinder-Pressure-Transducer Mounting Techniques to Maximize Data Accuracy
,”
SAE
Paper No. 900171.10.4271/900171
30.
Li
,
H.
,
Karim
,
G. A.
, and
Sohrabi
,
A.
,
2010
, “
An Experimental and Numerical Investigation of Spark Ignition Engine Operation on H2, CO, CH4, and Their Mixtures
,”
ASME J. Eng. Gas Turbines Power
,
132
(
3
), p.
032804
.10.1115/1.3155795
31.
Cooney
,
C.
,
Worm
,
J.
,
Michalek
,
D.
, and
Naber
,
J.
,
2008
, “
Wiebe Function Parameter Determination for Mass Fraction Burn Calculation in an Ethanol-Gasoline Fueled SI Engine
,”
J. KONES
,
15
(
3
), pp.
567
574
.http://yadda.icm.edu.pl/yadda/element/bwmeta1.element.baztech-article-BUJ8-0003-0040/c/httpwww_bg_utp_edu_plartjok32008jo20kones20200820no20320vol201520veliana.pdf
32.
Liu
,
J.
, and
Dumitrescu
,
C. E.
,
2018
, “
3D CFD Simulation of a CI Engine Converted to SI Natural Gas Operation Using the G-Equation
,”
Fuel
,
232
, pp.
833
844
.10.1016/j.fuel.2018.05.159
You do not currently have access to this content.