Thermoacoustic transfer functions of a full-scale gas turbine burner operating under full engine pressure have been measured. The excitation of the high-pressure test facility was done using a siren that modulated a part of the combustion airflow. Pulsation probes have been used to record the acoustic response of the system to this excitation. In addition, the flame’s luminescence response was measured by multiple photomultiplier probes and a light spectrometer. Three techniques to obtain the thermoacoustic transfer function are proposed and employed: two acoustic-optical techniques and a purely acoustic technique. The first acoustical-optical technique uses one single optical signal capturing the chemiluminescence intensity of the flame as a measure for the heat release in the flame. This technique only works if heat release fluctuations in the flame have only one generic source, e.g., equivalence ratio or mass flow fluctuations. The second acoustic-optical technique makes use of the different response of the flame’s luminescence at different optical wavelengths bands to acoustic excitation. It also works, if the heat release fluctuations have two contributions, e.g., equivalence ratio and mass flow fluctuation. For the purely acoustic technique, a new method was developed in order to obtain the flame transfer function, burner transfer function, and flame source term from only three pressure transducer signals. The purely acoustic method could be validated by the results obtained from the acoustic-optical techniques. The acoustic and acoustic-optical methods have been compared and a discussion on the benefits and limitations of each is given. The measured transfer functions have been implemented into a nonlinear, three-dimensional, time domain network model of a gas turbine with an annular combustion chamber. The predicted pulsation behavior shows a good agreement with pulsation measurements on a field gas turbine.
Skip Nav Destination
e-mail: daniel.guyot@tu-berlin.de
Article navigation
November 2010
Research Papers
Thermoacoustic Modeling of a Gas Turbine Using Transfer Functions Measured Under Full Engine Pressure
Felix Guethe,
Felix Guethe
Alstom (Switzerland) Ltd.
, CH-5405 Baden, Switzerland
Search for other works by this author on:
Douglas Pennell,
Douglas Pennell
Alstom (Switzerland) Ltd.
, CH-5405 Baden, Switzerland
Search for other works by this author on:
Daniel Guyot,
Daniel Guyot
Hermann-Föttinger-Institute,
e-mail: daniel.guyot@tu-berlin.de
Technische Universität Berlin
, 10623 Berlin, Germany
Search for other works by this author on:
Christian Oliver Paschereit
Christian Oliver Paschereit
Chair of Fluid Dynamics
Hermann-Föttinger-Institute,
Technische Universität Berlin
, 10623 Berlin, Germany
Search for other works by this author on:
Bruno Schuermans
Felix Guethe
Alstom (Switzerland) Ltd.
, CH-5405 Baden, Switzerland
Douglas Pennell
Alstom (Switzerland) Ltd.
, CH-5405 Baden, Switzerland
Daniel Guyot
Hermann-Föttinger-Institute,
Technische Universität Berlin
, 10623 Berlin, Germanye-mail: daniel.guyot@tu-berlin.de
Christian Oliver Paschereit
Chair of Fluid Dynamics
Hermann-Föttinger-Institute,
Technische Universität Berlin
, 10623 Berlin, GermanyJ. Eng. Gas Turbines Power. Nov 2010, 132(11): 111503 (9 pages)
Published Online: August 10, 2010
Article history
Received:
May 6, 2009
Revised:
May 7, 2009
Online:
August 10, 2010
Published:
August 10, 2010
Citation
Schuermans, B., Guethe, F., Pennell, D., Guyot, D., and Paschereit, C. O. (August 10, 2010). "Thermoacoustic Modeling of a Gas Turbine Using Transfer Functions Measured Under Full Engine Pressure." ASME. J. Eng. Gas Turbines Power. November 2010; 132(11): 111503. https://doi.org/10.1115/1.4000854
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Thermoacoustic Modeling of a Gas Turbine Combustor Equipped With
Acoustic Dampers
J. Turbomach (April,2005)
On the Use of Thermoacoustic Analysis for Robust Burner Design
J. Eng. Gas Turbines Power (May,2008)
Autoignition of Hydrogen and Air Inside a Continuous Flow Reactor With Application to Lean Premixed Combustion
J. Eng. Gas Turbines Power (September,2008)
Determination of Thermoacoustic Response in a Demonstrator Gas Turbine Engine
J. Eng. Gas Turbines Power (January,2002)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
QRAS Approach to Phased Mission Analysis (PSAM-0444)
Proceedings of the Eighth International Conference on Probabilistic Safety Assessment & Management (PSAM)
Alternative Systems
Turbo/Supercharger Compressors and Turbines for Aircraft Propulsion in WWII: Theory, History and Practice—Guidance from the Past for Modern Engineers and Students